Redirecting To An Oap Module From The Device; Configuring The Management Ip Address Of An Oap Module - H3C S9500 Series Operation Manual

Operation Manual – OAP Module
H3C S9500 Series Routing Switches
3) Input the IP address of either of the internal service interfaces as the SSH server
address. You can log in to the operating system of the OAP module after the
connection is established.

1.2.4 Redirecting to an OAP Module from the Device

You can redirect to the operating system of an OAP module from the device through the
following operation. In this way, the terminal display interface will be switched from the
command line interface on the device to the operating interface of the operating system
of the OAP module, and you can manage the system and application software on the
OAP module. After the switch, you can press Ctrl+k to return to the command line
interface on the device.
Follow the step to redirect from the device to the OAP module:
Redirect from the device
to the OAP module
1.3 Configuring the Management IP Address of an OAP
Module
In the OAA system, a device and an OAP module integrate together and function as
one device. For the snmp UDP Domain-based network management station (NMS),
however, a device and an OAP module are independent SNMP agents. Physically, two
agents are on the same managed object; while logically, they belong to two different
systems, and they manage their own MIB objects on the device and the module
separately. Therefore, when you use the NMS to manage the device and the OAP
module on the same interface, you must first obtain the management IP addresses of
the two SNMP agents and obtain the link relationship between them, and then you can
access the two agents. By default, the management IP address of an OAP module is
not configured.
Follow these steps to configure the management IP address of an OAP module:
Enter system view
Configure the management IP
address of an OAP module
To do...
oap connect slot
slot-number
To do...
Chapter 1 OAP Module Configuration
Use the command...
Use the command...
system-view
oap management-ip
ip-address slot slot-number
1-3
Remarks
Required
Available in user view
Remarks
—
Required
Not configured
by default.