H3C S9500 Series Operation Manual page 1438

Operation Manual – Information Center
H3C S9500 Series Routing Switches
Note:
The settings in the 7 directions are independent from each other. The settings will take
effect only after enabling the information center.
The information center of the switch has the following features:
Support to output log in 7 directions, i.e., Console, monitor to Telnet terminal,
logbuffer, loghost, trapbuffer, and SNMP log file.
The log is divided into 8 levels according to the significance and it can be filtered
based on the levels.
The information can be classified in terms of the source modules and the
information can be filtered in accordance with the modules.
The output language can be selected between Chinese and English.
1) Sending information to the loghost
Table 1-4 Send information to the loghost
Device
Switch
Loghost
2) Sending information to the console terminal
Configuration
Enable information
center
Set the information
output direction to the
loghost
Set information
source
Refer to configuration
cases for related log
host configuration
1-6
Chapter 1 Information Center
Default value
By default, the
Other configurations are
information
valid only if the information
center is
center is enabled.
enabled.
The configuration about
the loghost on the switch
and that on loghost must
— be the same; otherwise
the information cannot be
sent to the loghost
correctly
You can define which
modules and information
to be sent out and the
time-stamp format of
information, and so on.
—
You must turn on the
switch of the
corresponding module
before defining output
debugging information
— —
Configuration
description