H3C S9500 Series Operation Manual page 863

Operation Manual – MPLS VPLS
H3C S9500 Series Routing Switches
Batch delete the MAC
addresses of VPLS
instances
Caution:
You are not recommended to configure a remote static MAC address when there
are more than one peer relationship to the same remote system for a VSI instance.
In case you have configured a remote static MAC address and the peer IP address
you specified is the same as that of one of the NPEs in the H-VPLS of the instance,
the remote peer defaults to use dual-npe and the word dual-npe will be displayed
when you view the MAC forwarding entries. You may not delete the MAC
configuration thoroughly by specifying the peer IP address. To delete the MAC
configuration completely, you need to specify the MAC address.
1.2.9 Enabling VLAN VPN on a Port
Caution:
User access mode of VSI determines whether you should enable VLAN-VPN on a port
or not. If the access mode is Ethernet, you must enable VLAN-VPN on the access port
such that your private VLAN Tag can be properly transferred. If the access mode is
VLAN, you must set the access port to Trunk.
Perform the following configuration in Ethernet port view to enable VLAN VPN on a
port:
Enable VLAN VPN on a port
Disable VLAN VPN on the port
To do...
undo mac-address vsi [ vsi-name [ peer { peer-ip |
dual-npe } | vlan-interface vlan-id ] ] [ static |
dynamic ]
To do...
Use the command...
Use the command...
vlan-vpn enable
undo vlan-vpn
1-12
Chapter 1 VPLS Configuration