H3C S9500 Series Operation Manual page 880

Operation Manual – MPLS VPLS
H3C S9500 Series Routing Switches
[NPE1-vsi-Hvpls] broadcast-restrain 100
[NPE1-vsi-Hvpls] bandwidth 1024000
[NPE1-vsi-Hvpls] quit
# Bind the VPLS instance to the private network interface.
[NPE1] vlan 3001
[NPE1-vlan3001] interface vlan-interface 3001
[NPE1-Vlan-interface3001] l2 binding vsi Hvpls access-mode ethernet
[NPE1-Vlan-interface3001] quit
2) Configure NPE2.
Note:
In this part of the example, both slot 2 and slot 4 hold the MPLS cards.
If the access card on the public network side is an MPLS card, you simply need to
redirect the VPLS packets to the VPLS service card for redirection, without using the
join-vlan parameter.
If the access card on the public network side is a non-MPLS card, you need to
redirect the VPLS packets to the VPLS service card for redirection and use the
join-vlan parameter to add the ports to the VLANs.
# Configure MPLS globally.
<H3C> system view
[H3C] sysname NPE2
[NPE2] mpls lsr-id 2.2.2.2
[NPE2] mpls
[NPE2-mpls] quit
[NPE2] mpls ldp
# Configure the public network interfaces, loopback interface, and routing.
[NPE2] router id 2.2.2.2
[NPE2] interface LoopBack 0
[NPE2-LoopBack0] ip address 2.2.2.2 32
[NPE2-LoopBack0] quit
[NPE2] vlan 26
[NPE2-vlan26] interface vlan-interface 26
[NPE2-Vlan-interface26] ip address 26.26.26.2 24
[NPE2-Vlan-interface26] quit
[NPE2] interface Ethernet 2/1/26
[NPE2-Ethernet2/1/26] port link-type trunk
[NPE2-Ethernet2/1/26] port trunk permit vlan 26
[NPE2-Ethernet2/1/26] undo port trunk permit vlan 1
1-29
Chapter 1 VPLS Configuration