H3C S9500 Series Operation Manual page 996

Operation Manual – MPLS OAM
H3C S9500 Series Routing Switches
Configure MPLS basic capabilities, refer to MPLS Configuration.
Configure static LSPs, refer to MPLS Configuration.
3) Data preparation
To configure MPLS OAM basic capability, prepare the following data:
Table 1-4 Data preparation
Number
1
2
3
4
If the ingress node adopts a shared reverse channel, the No. 3 data in the above table
is omitted.
II. Configuration Procedure
Follow these steps to configure MPLS OAM basic capability:
Enter system view
Enable MPLS OAM
Configure MPLS OAM
parameters for the
ingress node
Enable OAM for the
ingress node
Configure MPLS OAM
parameters for the
egress node
Enable OAM for the
egress node
The static LSP to be verified
For ingress node, LSP ID of the static LSP to be verified
For egress node, the ingress LSR ID and LSP ID of the static LSP to
be verified
The static LSP of the reverse channel
MPLS OAM parameters, for instance, verification packet type and
FFD transmission frequency
To do...
system-view
mpls oam
mpls oam ingress lsp-name
lsp-name lsp-id lsp-id [ type { cv | ffd
[ frequency ffd-fre ] } ] [ backward-lsp
share | lsp-name rev-lsp-name ]
mpls oam ingress enable { all |
lsp-name lsp-name }
mpls oam egress lsp-name
lsp-name lsr-id lsr-id lsp-id lsp-id
[ type { cv | ffd [ frequency ffd-fre ] } ]
[ backward-lsp rev-lsp-name [ private
| share ] ]
mpls oam egress enable { all |
lsp-name lsp-name }
Chapter 1 MPLS OAM Configuration
Data
Use the command...
1-8
Remarks
—
Required
Required
Required
Required
Required