Vpls Configuration Examples - H3C S9500 Series Operation Manual

Operation Manual – MPLS VPLS
H3C S9500 Series Routing Switches
Caution:
If a VSI instance is configured with a static MAC to a NPE in the H-VPLS model of
the instance, the MAC address forwarding table will display the dual-npe instead of
the specific IP addresses.
If a static MAC address to the peer is configured for a VSI instance, and the peer IP
address is the same with one of the NPEs in the H-VPLS model of the instance, then
the remote system defaults to use dual-npe, and dual-npe is displayed in the MAC
address forwarding table.
II. Debugging VPLS
To do...
Enable individual
kinds of L2VPN
debugging
Disable individual
kinds of L2VPN
debugging
By default, all debugging is disabled.

1.4 VPLS Configuration Examples

1.4.1 VPLS Basic Configuration Example (1)
Caution:
When using an RRPP ring network to provide VPLS traffic, you are not recommended
to use the same port as both the VPLS private network port and the port on the RRPP
ring. If this is not avoidable, be sure to use the secondary port of the RRPP master node
as the VPLS private network port.
I. Network requirements
S9500 series switch support all kinds of VPLS architectures and networking.
shows a simple back-to-back network diagram. Where, two sites of VPN1 connect to
Use the command...
debugging mpls l2vpn
{ advertisement | all | connections
[ interface vlan-interface vlan-id ] |
error | event | loadshare | switchover }
undo debugging mpls l2vpn
{ advertisement | all | connections |
error | event | loadshare | switchover }
1-18
Chapter 1 VPLS Configuration
Remarks
Available in user
view
Available in user
view
Figure 1-4