H3C S9500 Series Operation Manual page 1002

Routing switches
Hide thumbs Also See for S9500 Series:
Table of Contents

Advertisement

Operation Manual – MPLS OAM
H3C S9500 Series Routing Switches
[SwitchA] mpls oam ingress lsp-name LspAtCw lsp-id 100
[SwitchA] mpls oam ingress lsp-name LspAtCp lsp-id 200
# Configure a protection group.
[SwitchA] mpls protect-switch 1 work-lsp lspAtCw protect-lsp lspAtCp holdoff
10 mode revertive wtr 20
Using the display mpls protect-switch all command, you will see the following
information:
[SwitchA] display mpls protect-switch all
-----------------------------------------------------------------------
-----------------------------------------------------------------------
PROTECT-ID
1
# Enable MPLS OAM on the ingress node.
[SwitchA] mpls oam ingress enable all
5)
Configure MPLS OAM for Switch C
# Enable MPLS OAM globally.
<SwitchC> system-view
[SwitchC] mpls oam
# Configure OAM parameters for the egress node.
[SwitchC] mpls oam egress lsp-name lspAtCw lsr-id 1.1.1.1 lsp-id 100
backward-lsp lspCtA share
[SwitchC] mpls oam egress enable lsp-name lspAtCw
[SwitchC] mpls oam egress lsp-name lspAtCp lsr-id 1.1.1.1 lsp-id 200
backward-lsp lspCtA share
[SwitchC] mpls oam egress enable lsp-name lspAtCp
After completing the above configurations, you can view information about the current
LSP and OAM and statistics of OAM verification packets on Switch A and Switch C.
The following takes the display on Switch C as an example.
# Display configuration information about the current LSP and OAM.
<SwitchC> display mpls oam egress all verbose
--------------------------------------------------------------------------
Verbose information about the 1st OAM at egress
--------------------------------------------------------------------------
lsp basic information:
--------------------------------------------------------------------------
Lsp-name
Lsp signal status
Lsp incoming Label
Protection-Switching Information
Dft-W
Dft-P
No-defect
No-defect
: lspAtCw
: Up
: 3
1-14
Chapter 1 MPLS OAM Configuration
Ctrl-W
Ctrl-P
Up
Up
oam basic information:
Oam-Index
Oam select board
Enable-state
SwitchRst
W
: 1024
: 2
: --

Advertisement

Table of Contents
loading

Table of Contents