H3C S9500 Series Operation Manual page 1283

Operation Manual – Login and User Interface
H3C S9500 Series Routing Switches
Specify the Ethernet port connected with the PC to belong to the management
VLAN (use the port command in VLAN view)
If the PC and the switch's port connected with the PC reside in the same LAN, their
IP addresses must be configured to reside in the same network segment.
Otherwise, the PC and the Switch must be reachable to each other.
Then, you can telnet to the Ethernet Switch to configure it.
Follow the given steps below:
Step 1: Before logging into the switch through telnet, you need to configure the Telnet
user name and password on the switch through the console port.
Note:
By default, the password is required for authenticating the Telnet user to log into the
switch. If a user tries to log in through Telnet without a password, the system will prompt
that the login fails because no password is set.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] user-interface vty 0
[H3C-ui-vty0] set authentication password simple xxxx (xxxx is the login
password of Telnet user)
Step 2: To set up the configuration environment, connect the Ethernet port of the PC to
that of the switch via the LAN, as shown in
W orkstation
Figure 1-5 Set up configuration environment through telnet
Step 3: Run Telnet on the PC and input the IP address of the VLAN connected to the PC
port, as shown in
Ethernet
Workstation
Server
Figure 1-6.
Figure 1-5.
Switch
M - Ethernet
（ for
PC
the switch via
configuring
telnet ）
1-3
Chapter 1 Switch Login