Vpls Basic Configuration; Vpls Configuration Task List - H3C S9500 Series Operation Manual

Operation Manual – MPLS VPLS
H3C S9500 Series Routing Switches

1.2 VPLS Basic Configuration

1.2.1 VPLS Configuration Task List

Configure routing protocol
for public network
Configure basic MPLS
functions
Configure LDP expansion
session peer
Enabling L2VPN
Configure a VPLS
instance
Configure an IP address
of a peer PE
Configure static MAC
addresses
Configure VLAN for user
access and binding VSI
Configure VPLS
characteristics
Enable VLAN VPN
(Q-in-Q) on port
Configure user-defined
flow template
Configure ACL rules
Configure packet
redirection
Enable VPLS load sharing
To do...
Refer to the related sections in
Operation Manual – Routing
Protocol
Refer to chapter 2 Configuring
MPLS Basic Functions in
Operation Manual – MPLS
mpls ldp remoter-peer index
mpls l2vpn
vsi vsi-name [ static ]
peer peer-ip [ vc-id vc-id ]
[ upe | dual-npe ]
[ encapsulation { ethernet |
vlan } ]
mac-address { static H-H-H }
vsi vsi-name { peer { peer-ip |
dual-npe } | vlan-interface
vlan-id }
l2 binding vsi vsi-name
[ access-mode { vlan |
ethernet } ]
bandwidth bw-limit
vlan-vpn enable
flow-template user-defined
slot slotnum template-info
rule rule-id permit mpls
l2label-range ingress any
egress any
traffic-redirect inbound
link-group { acl-number |
acl-name } [ rule rule
[ system-index index ] ] | slot
slotid vlanid [ join-vlan ] }
vpls-load-share enable
Use the command...
1-7
Chapter 1 VPLS Configuration
Remarks
Required
Required
Required
Required
Required. static is
required for
configuring a VSI.
Required
Optional
Required
Optional
Optional
Required
Required
Required
Optional
Enabled by default