H3C S9500 Series Operation Manual page 1390

Operation Manual – Device Management
H3C S9500 Series Routing Switches
1.4.2 Using the Switch as an FTP Server to Implement the Remote Upgrade
I. Network requirements
The switch serves as an FTP server and the PC as an FTP client. The configuration on
the FTP server is as follows: an FTP user is configured with the name "switch", the
password "hello" and the read & write authority over the root directory of the switch. The
IP address of a VLAN interface on the switch is 1.1.1.1, and the IP address of the PC is
2.2.2.2. The switch and PC are reachable with each other.
The switch application switch.app is stored on the PC. Using FTP, this file can be
uploaded from the PC to the switch remotely, and the configuration file
switch20080101.cfg on the switch can be downloaded to the PC as a backup.
II. Network diagram
Figure 1-2 Network diagram for FTP configuration
III. Configuration procedure
1) Configure the switch
# Log in to the switch
Log in to the switch through the console port locally or through telnet remotely (refer to
Login and User Interface Configuration of this manual for details about the login
modes).
# Enable FTP on the switch; configure a username, password and path.
<H3C> system-view
[H3C] ftp server enable
[H3C] local-user switch
[H3C-luser-switch] service-type ftp ftp-directory flash:
[H3C-luser-switch] password simple hello
1-8
Chapter 1 Device Management