H3C S9500 Series Operation Manual page 1037

Operation Manual – QoS
H3C S9500 Series Routing Switches
II. Configuring traffic parameters (optional)
Use the following command to set the traffic parameters required before configuring
traffic policing on service processor boards.
Caution:
This operation is not required for configuring traffic policing on common boards.
Perform the following configuration in system view.
Configure traffic parameters
III. Configuring traffic policing
The purpose of this configuration task is to implement traffic policing on ACL-matched
data streams, and then take normal actions on data streams within the traffic limit and
take other actions (discarding packets, for example) on those exceeding the limit.
For interface boards, perform the following configurations in Ethernet port view.
Configure traffic policing which only
applies IP group ACL
Remove traffic policing setting
which only applies IP group ACL
Configure traffic policing which
applies IP group ACL and link
group ACL at same time
To do...
traffic-params traffic-index cir committed-info-rate
cbs committed-base-size ebs exceed-base-size [ pir
peak-info-rate ]
To do...
Use the command...
Use the command...
traffic-limit inbound ip-group { acl-number |
acl-name } [ rule rule [ system-index index ] ]
[ tc-index index ] cir cbs ebs [ pir ] [ conform
{ { remark-cos | remark-drop-priority } * |
remark-policed-service } ] [ exceed
{ forward | drop } ]
undo traffic-limit inbound ip-group
{ acl-number | acl-name } [ rule rule ]
traffic-limit inbound ip-group { acl-number |
acl-name } { rule rule link-group { acl-number
| acl-name } [ rule rule [ system-index
index ] ] | link-group { acl-number | acl-name }
rule rule } [ tc-index index ] cir cbs ebs [ pir ]
[ conform { { remark-cos |
remark-drop-priority } * |
remark-policed-service } ] [ exceed
{ forward | drop } ]
1-10
Chapter 1 QoS Configuration