H3C S9500 Series Operation Manual page 1444

Operation Manual – Information Center
H3C S9500 Series Routing Switches
When defining the information sent to the loghost, channel-number or channel-name
must be set to the channel that corresponds to loghost direction.
Every channel has been set with a default record, whose module name is default and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Note:
If you want to view the debugging information of some modules on the switch, you must
select debugging as the information type when configuring information source,
meantime using the debugging command to turn on the debugging switch of those
modules.
4) Configuring the loghost
The configuration on the loghost must be the same with that on the switch. For related
configuration, see the configuration examples in the later part.
1.2.3 Sending Information to Console terminal
To send configuration information to console terminal, follow the steps below:
1) Enabling information center
Enable information center
Disable information center
Note:
Information center is enabled by default. After information center is enabled, system
performances are affected when the system processes much information because of
information classification and outputting.
2) Configuring to output information to console terminal
Output information to
Console
To do...
info-center enable
undo info-center enable
To do...
info-center console channel
{ channel-number | channel-name }
Use the command...
Use the command...
1-12
Chapter 1 Information Center
Remarks
Available in system view
Available in system view
Remarks
Available in
system view