H3C S9500 Series Operation Manual page 1080

Operation Manual – QoS
H3C S9500 Series Routing Switches
7) When an ACL is applied to a VLAN, if a port in this VLAN is unavailable due to that
the board where the port resides is not in position, the port will not synchronize to
the ACL after the board is in position. For the port to synchronize to the ACL, you
can use the port can-access vlan-acl command on the port.
Caution:
VLAN-ACL does not take effect on the ports of the XP4B and XP4CA boards.
VLAN-ACL does not take effect on the internal ports of the OAP module.
5.3 VLAN-ACL Configuration Examples
5.3.1 VLAN-ACL Traffic Redirecting Configuration Example
I. Network requirements
Redirect all the packets forwarded by GigabitEthernet 7/1/1 and GigabitEthernet 7/1/2
from 8:00 to 18:00 every day to 3.0.0.1/8.
II. Network diagram
GE7/1/1
VLAN2
PC A
1.0.0.1/8
Figure 5-1 Network diagram for VLAN-ACL configuration
III. Configuration procedure
1) Define the time range.
# Define the time range from 8:00 to 18:00.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] time-range test 8:00 to 18:00 daily
2) Define traffic rules.
GE7/1/8
GE7/1/2
VLAN3
PC B
2.0.0.1/8
5-4
Chapter 5 VLAN-ACL Configuration