H3C S9500 Series Operation Manual page 1452

Operation Manual – Information Center
H3C S9500 Series Routing Switches
Cancel the configuration
of outputting information
to trap buffer
By default, the switch outputs information to the trap buffer in the CPU. The size of the
trap buffer is 256, that is, the trap buffer can hold up to 256 messages.
3) Configuring information source on the switch
By this configuration, you can define the information that sent to trap buffer is generated
by which modules, information type, information level, and so on.
Define information source
Cancel the configuration
of information source
When defining the information sent to trap buffer, channel-number or channel-name
must be set to the channel that corresponds to trapbuffer direction.
Every channel has been set with a default record, whose module name is default and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Note:
If you want to view the debugging information of some modules on the switch, you must
select debugging as the information type when configuring information source,
meantime using the debugging command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
This configuration will affect the timestamp of the displayed information.
Perform the following configuration to configure the output format of time-stamp:
To do...
undo info-center
trapbuffer [ channel |
size ]
To do...
info-center source { modu-name |
default } channel { channel-number |
channel-name } [ debug { level severity |
state state }* | log { level severity | state
state }* | trap { level severity | state
state }* ]*
undo info-center source { modu-name
| default | all } channel
{ channel-number | channel-name }
Use the command...
Use the command...
1-20
Chapter 1 Information Center
Remarks
Available in system view
Remarks
Available in
system
view
Available in
system
view