H3C S9500 Series Operation Manual page 1003

Operation Manual – MPLS OAM
H3C S9500 Series Routing Switches
Lsp ingress lsr-id
oam detect information:
--------------------------------------------------------------------------
Type
Frequency
Detect-state
Defect-state
--------------------------------------------------------------------------
Verbose information about the 2nd OAM at egress
--------------------------------------------------------------------------
lsp basic information:
--------------------------------------------------------------------------
Lsp-name
Lsp signal status
Lsp incoming Label
Lsp ingress lsr-id
oam detect information:
--------------------------------------------------------------------------
Type
Frequency
Detect-state
Defect-state
--------------------------------------------------------------------------
Total Oam Num:
Total Start Oam Num:
Total Defect Oam Num:
# Display the statistics of verification packets received on the egress node.
<SwitchC> display mpls oam egress receive-packet all slot 2
--------------------------------------------------------------------------
CV Packet
--------------------------------------------------------------------------
467
6) Verify the configuration
Shutdown interface VLAN12 of Switch B. At this point, the primary LSP on Switch A
detects a defect.
: 1.1.1.1
: CV
: 1 s
: Start
: No-defect
: lspAtCp
: Up
: 3
: 1.1.1.1
: CV
: 1 s
: Start
: No-defect
FFD Packet FDI Packet
0 0
1-15
Chapter 1 MPLS OAM Configuration
Auto-protocol
Auto-overtime
Ttsi/lsr-id
Ttsi/lsp-id
oam backward information:
Share attribute
Lsp-name
Lsp-state
oam basic information:
Oam-Index
Oam select board
Enable-state
Auto-protocol
Auto-overtime (s)
Ttsi/lsr-id
Ttsi/lsp-id
oam backward information:
Share attribute
Lsp-name
Lsp-state
2
2
0
AP-FDI Packet
0
:Disable
(s) : 0
: 1.1.1.1
: 100
: Share
: lspCtA
: Up
: 1025
: 2
: --
: Disable
: 0
: 1.1.1.1
: 200
: Share
: lspCtA
: Up
Error Packet
0