Setting Up Configuration Environment Through Telnet; Connecting A Pc To The Switch Through Telnet - H3C S9500 Series Operation Manual

Operation Manual – Login and User Interface
H3C S9500 Series Routing Switches
Figure 1-3 Configure the port for connection
Figure 1-4 Set communication parameters
Step 3: The switch is powered on. Display self-test information of the switch and prompt
you to press Enter to show the command line prompt such as <H3C>.
Step 4: Input a command to configure the switch or view the operation state. Input a "?"
for help. For details of specific commands, refer to the following chapters.

1.2 Setting Up Configuration Environment Through Telnet

1.2.1 Connecting a PC to the Switch Through Telnet

To telnet to the Ethernet Switch, ensure that the following conditions are satisfied:
Assign an IP address to the management VLAN interface correctly in the Ethernet
Switch (use the ip address command in VLAN interface view).
1-2
Chapter 1 Switch Login