H3C S9500 Series Operation Manual page 1413

Operation Manual – Cluster Management
H3C S9500 Series Routing Switches
Configure the switch
using the default
configuration settings
Display the management
IP address and subnet
mask of the switch and
the IP address of the
default gateway
Set or remove the
management IP address
and subnet mask of the
switch and the IP address
of the default gateway
Set the management
MAC address for the
switch
Configure the port tag
status, and the
relationship between
switch ports and VLANs
Set the VLAN data of the
Ethernet switch
Set working mode for
specified ports of the
Ethernet switch
Allow the specified port
self loopback
Prohibit the specified port
self loopback
Close specified switch
ports
Enable specified switch
ports
You can use the auto config command to configure specified ports with the default
configuration settings, such as port rate, flow control, duplex state, and tag state. When
executing the auto config command, you must provide the port-start-vlanid argument
to specify the starting VLAN ID of the specified port, through which you can add multiple
ports to one VLAN.
You can perform these configurations locally. Refer to the corresponding operation
manual of the switch you are configuring for more information.
To do...
auto config default
port-start-vlanid
query ip address
set ip address
ip-address mask
[ gateway-address ]
set mac mac-address
set port port-list vlanid
vlan-id-list [ tagged |
untagged ]
set vlan vlan-index-list
{ vlanid vlan-id-list
[ port-list ] | broadcast
port-list [ vlan-id-list ] }
set workmode port-list
{ auto | 10m-full |
10m-half | 100m-full |
100m-half }
loop port port-list
undo loop port port-list
close port port-list
undo close port port-list
Use the command...
1-12
Chapter 1 HGMP V1 Configuration
Remarks
Available in lanswitch
view
Available in lanswitch
view
Available in lanswitch
view
Available in lanswitch
view
Available in lanswitch
view
Available in lanswitch
view
Available in lanswitch
view
Available in lanswitch
view
Available in lanswitch
view
Available in lanswitch
view
Available in lanswitch
view