H3C S9500 Series Operation Manual page 1454

Operation Manual – Information Center
H3C S9500 Series Routing Switches
Define information source
Cancel the configuration
of information source
modu-name specifies the module name; default represents all the modules; all
represents all the information filter configuration in channel channel-number except
default level refers to the severity levels; severity specifies the severity level of
information. The information with the level below it will not be output. channel-number
specifies the channel number and channel-name specifies the channel name.
When defining the information sent to SNMP NM, channel-number or channel-name
must be set to the channel that corresponds to SNMP direction.
Every channel has been set with a default record, whose module name is default and
the module number is 0xffff0000. However, for different channels, the default record
may have different default settings of log, trap and debugging. When there is no
specific configuration record for a module in the channel, use the default one.
Note:
If you want to view the debugging information of some modules on the switch, you must
select debugging as the information type when configuring information source,
meantime using the debugging command to turn on the debugging switch of those
modules.
You can use the following commands to configure log information, debugging
information and the time-stamp output format of trap information.
This configuration will affect the timestamp of the displayed information.
Perform the following configuration to configure the output format of time-stamp:
Configure the output
format of the time-stamp
To do...
info-center source { modu-name |
default } channel
{ channel-number | channel-name }
[ debug { level severity | state
state }* | log { level severity | state
state }* | trap { level severity | state
state }* ]*
undo info-center source
{ modu-name | default | all }
channel { channel-number |
channel-name }
To do...
info-center timestamp
{ log | trap | debugging }
{ boot | date | none }
Use the command...
Use the command...
1-22
Chapter 1 Information Center
Remarks
Available in
system view
Available in
system view
Remarks
Available in system view