Setting The Supported Type Of Radius Server - H3C S9500 Series Operation Manual

Operation Manual – AAA RADIUS HWTACACS
H3C S9500 Series Routing Switches
responds or discards the messages after transmitting for specified times. You can use
the following command to set whether or not to save the stop-accounting requests.
Perform the following operations in RADIUS scheme view to enable/disable
stop-accounting request buffer:
Enable stop-accounting request buffer
Disable stop-accounting request buffer
By default, the stop-accounting request will be saved in the buffer.
1.3.14 Setting the Maximum Retransmitting Times of Stop-Accounting
Request
Because the stop-accounting request concerns account balance and will affect the
amount of charge, which is very important for both the subscribers and the ISP, NAS
shall make its best effort to send the message to RADIUS accounting server.
Accordingly, if the request from H3C Series Switch to RADIUS accounting server has
not been responded, switch shall save it in the local buffer and retransmit it until the
server responds or discards the messages after transmitting for specified times. Use
the following command to set the maximum retransmission times.
Perform the following operations in RADIUS scheme view to configure the maximum
times of retransmitting stop-accounting requests:
Set the maximum times of retransmitting
stop-accounting request
Restore the maximum times of retransmitting
stop-accounting request to the default value
By default, the stop-accounting request can be retransmitted for up to 500 times.

1.3.15 Setting the Supported Type of RADIUS Server

H3C Series Switches support the standard RADIUS protocol and the extended
RADIUS service platforms, such as IP Hotel, 201+ and Portal developed by Huawei.
You can use the following command to set the supported types of RADIUS servers.
Perform the following operations in RADIUS scheme view to configure the supported
type of RADIUS scheme:
To do...
To do...
1-23
Chapter 1 AAA, RADIUS and HWTACACS
Use the command...
stop-accounting-buffer enable
undo stop-accounting-buffer enable
Use the command...
retry stop-accounting
retry-times
undo retry stop-accounting
Protocol Configuration