Operation Manual – Portal
H3C S9500 Series Routing Switches
Configure the Portal rate
limit function on upload
interfaces
1.4.2 Portal Rate Limit Function Configuration Example
I. Network requirements
The upload interface for Portal rate limit is specified.
II. Network diagram
Refer to
III. Configuration procedure
# Specify Ethernet 2/1/10 as the upload interface for Portal rate limit.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] interface Ethernet 2/1/10
[H3C-Ethernet2/1/10] portal upload-interface
1.5 Portal User Deletion
1.5.1 Portal User Deletion Procedure
Table 1-4 Portal user deletion procedure
Enter system view
Delete the Portal user using the
specified IP address
To do...
portal upload interface
Figure
1-2.
To do...
Use the command...
Use the command...
system-view
portal delete-user
ip-address
1-22
Chapter 1 Portal Configuration
Remarks
By default, the Portal rate
limit function is disabled.
Remarks
—
—