H3C S9500 Series Operation Manual page 1443

Operation Manual – Information Center
H3C S9500 Series Routing Switches
Perform the following configuration to output information to the loghost:
Output information to the
loghost
Cancel the configuration
of outputting information
to loghost
Note that the IP address of log host must be correct.
Note:
Ensure to enter the correct IP address using the info-center loghost command to
configure loghost IP address. If you enter a loopback address, the system prompts of
invalid address appears.
3) Configuring information source on the switch
By this configuration, you can define the information that sent to console terminal is
generated by which modules, information type, information level, and so on.
Perform the following configuration to define information source:
Define information
source
Cancel the
configuration of
information source
modu-name specifies the module name; default represents all the modules; all
represents all the information filter configuration in channel channel-number except
default; level refers to the severity levels; severity specifies the severity level of
information. The information with the level below it will not be output. channel-number
specifies the channel number and channel-name specifies the channel name.
To do...
info-center loghost { source
interface-type interface-number |
host-ip-addr [ channel
{ channel-number |
channel-name } | facility
local-number | language
{ chinese | english } ]* }
undo info-center loghost
host-ip-addr
To do...
info-center source { modu-name |
default } channel { channel-number |
channel-name } [ debug { level
severity | state state }* | log { level
severity | state state }* | trap { level
severity | state state }* ]*
undo info-center source
{ modu-name | default | all } channel
{ channel-number | channel-name }
Use the command...
Use the command...
1-11
Chapter 1 Information Center
Remarks
Available in
system view
Available in
system view
Remarks
Available in
system view
Available in
system view