H3C S9500 Series Operation Manual page 1442

Operation Manual – Information Center
H3C S9500 Series Routing Switches
Table 1-10 Send information to a log file
Device
Switch
1.2.2 Sending Information to the Loghost
To send configuration information to the loghost, follow the steps below:
1) Enabling information center
Perform the following configuration to enable/disable information center:
Enable information center
Disable information center
Note:
Information center is enabled by default. After information center is enabled, system
performances are affected when the system processes much information because of
information classification and outputting.
2) Outputting information to the loghost
Configuration
Enable the
By default, the information
information
center is enabled.
center
By default, the Switch
outputs information to a log
Set the Switch file, the allowed size of each
to send log file is 2 Mbytes, the
information to system allows you to save a
a log file maximum of 5 log files, and
log files are saved under
cf:/logfile.
Configure an
information —
source
To do...
info-center enable
undo info-center enable
Default value
Use the command...
1-10
Chapter 1 Information Center
Configuration
description
Other configurations do
not take effect unless
the information center is
enabled.
You can configure the
allowed size of each log
file (1 to 5 Mbytes),
allowed number of
saved log files, and
directory under which to
save a log file
You can define the
modules and
information that can be
sent out. If you
configure the Switch to
output debugging
information, you must
enable debugging for
the corresponding
modules.
Remarks
Available in system view
Available in system view