Remote Switch App Upgrade Configuration Example - H3C S3100 Series Operation Manual

Operation Manual (For Soliton) – System Maintenance and Debugging
H3C S3100 Series Ethernet Switches
Table 4-10 Display the operating status of the device management
Display the APP to be adopted
at next startup
Display the module type and
operating status of each board
Display CPU usage of a switch
Display memory usage of a
switch
Display the operating status of
the power supply
Display system diagnostic
information or save system
diagnostic information to a file
with the extension .diag into
the Flash memory
Display enabled debugging on
the switch

4.4 Remote Switch APP Upgrade Configuration Example

I. Network requirements
Telnet to the switch from a PC remotely and download applications from the FTP server
to the Flash memory of the switch. Update the switch software by using the device
management commands through CLI.
The switch acts as the FTP client, and the remote PC serves as both the configuration
PC and the FTP server.
Perform the following configuration on the FTP server.
Configure an FTP user, whose name is switch and password is hello. Authorize
the user with the read-write right on the directory Switch on the PC.
Make configuration so that the IP address of a VLAN interface on the switch is
1.1.1.1, the IP address of the PC is 2.2.2.2, and the switch and the PC is reachable
to each other.
The host software switch.bin and the Boot ROM file boot.btm of the switch are stored in
the directory switch on the PC. Use FTP to download the switch.bin and boot.btm files
from the FTP server to the switch.
Operation Command
display boot-loader [ unit
unit-id ]
display device [ manuinfo | unit
unit-id ]
display cpu [ unit unit-id ]
display memory [ unit unit-id ]
display power [ unit unit-id
[ power-id ] ]
display diagnostic-information
display debugging [ unit unit-id ]
[ interface interface-type
interface-number ]
[ module-name ]
4-6
Chapter 4 Device Management
Description
You can
execute the
display
command in
any view.