H3C S9500 Series Operation Manual page 1441

Operation Manual – Information Center
H3C S9500 Series Routing Switches
Table 1-9 Send information to SNMP
Device
Switch
Network
management
workstation
7) Sending information to a log file
Configuration
Enable information
center
Set the information
output direction to
SNMP
Set information source
Configure SNMP
features
The same as the SNMP
configuration of the
switch
1-9
Chapter 1 Information Center
Default Configuration
value description
By default,
Other configurations are
information
valid only if the information
center is
center is enabled
enabled
— —
You can define which
modules and information
to be sent out and the
time-stamp format of
information, and so on.
—
You must turn on the
switch of the
corresponding module
before defining output
debugging information
Refer to SNMP
— Configuration in the
System Volume.
— —