Acl Configuration Examples; Basic Acl Configuration Example - H3C S9500 Series Operation Manual

Operation Manual – ACL
H3C S9500 Series Routing Switches
Display the configuration
information of the flow
template
Clear ACL statistics
The display acl config command only displays the ACL matching information
processed by the CPU.
See the corresponding Command Manual for description of parameters.

1.4 ACL Configuration Examples

1.4.1 Basic ACL Configuration Example

I. Network requirements
With proper basic ACL configuration, during the time range from 8:00 to 18:00 everyday
the switch filters out the packets from the host with source IP 10.1.1.1 (the host is
connected through the port Ethernet2/1/1 to the switch.)
II. Network diagram
Figure 1-1 Network diagram for basic ACL configuration
III. Configuration procedure
Note:
Only the commands concerning ACL configuration are listed here.
1) Define the time range.
# Define a time range ranging from 8:00 to 18:00.
<H3C> system-view
[H3C] time-range test 8:00 to 18:00 daily
To do...
display flow-template [ default
| interface interface-type
interface-number | slot slot-id |
user-defined ]
reset acl counter { all |
acl-number | acl-name }
Use the command...
1-15
Chapter 1 ACL Configuration
Remarks
Available in any
view
Available in user
view