H3C S9500 Series Operation Manual page 1449

Operation Manual – Information Center
H3C S9500 Series Routing Switches
For example, if you have specified the log information as the information sent to the
Telnet terminal or dumb terminal, now you need to use the terminal monitor command
to enable the terminal display function and the terminal logging command to enable
the terminal display function of log information on the switch, then you can view the
information at the Telnet terminal or dumb terminal.
Perform the following configuration to enable terminal display function:
Enable terminal display function of
log, debugging and trap information
Disable terminal display function of
the above information
Enable terminal display function of
debugging information
Disable terminal display function of
debugging information
Enable terminal display function of
log information
Disable terminal display function of
log information
Enable terminal display function of
trap information
Disable terminal display function of
trap information
1.2.5 Sending Information to the Log Buffer
To send configuration information to the log buffer, follow the steps below:
1) Enabling information center
Enable information center
Disable information center
Note:
Information center is enabled by default. After information center is enabled, system
performances are affected when the system processes much information because of
information classification and outputting.
To do...
To do...
info-center enable
undo info-center enable
Use the command...
terminal monitor
undo terminal monitor
terminal debugging
undo terminal
debugging
terminal logging
undo terminal logging
terminal trapping
undo terminal trapping
Use the command...
1-17
Chapter 1 Information Center
Remarks
Available in user
view
Available in user
view
Available in user
view
Available in user
view
Available in user
view
Available in user
view
Available in user
view
Available in user
view
Remarks
Available in system view
Available in system view