H3C S9500 Series Operation Manual page 1059

Operation Manual – QoS
H3C S9500 Series Routing Switches
[H3C] acl number 3000
[H3C-acl-adv-3000] rule 0 permit ip precedence 7
[H3C-acl-adv-3000] rule 1 permit ip precedence 6
[H3C-acl-adv-3000] rule 2 permit ip precedence 5
[H3C-acl-adv-3000] rule 3 permit ip precedence 4
[H3C-acl-adv-3000] quit
[H3C] acl number 3100
[H3C-acl-adv-3100] rule 0 permit ip precedence 3
[H3C-acl-adv-3100] rule 1 permit ip precedence 2
[H3C-acl-adv-3100] rule 2 permit ip precedence 1
[H3C-acl-adv-3100] rule 3 permit ip precedence 0
[H3C-acl-adv-3100] quit
# Apply traffic redirecting rules to GigabitEthernet 2/1/2.
[H3C] interface GigabitEthernet 2/1/2
[H3C-GigabitEthernet2/1/2] traffic-redirect inbound ip-group 3000 next-hop
20.20.20.1
[H3C-GigabitEthernet2/1/2] traffic-redirect inbound ip-group 3100 next-hop
20.20.30.1
1.4.7 Queue Scheduling Configuration Example
I. Network requirements
Modify the correspondence between 802.1p priority levels and local priority levels to
change the mapping between 802.1p priority levels and queues. That is, put packets
into output queues according to the new mapping. Use WRR algorithm for the queues 0
to 5 at the port GE7/1/1. Set the queues 0, 1 and 2 into WRR queue 1, with weight
respectively as 20, 20 and 30; set the queues 3, 4 and 5 into WRR queue 2, with weight
respectively as 20, 20 and 40. The queues 6 and 7 use SP algorithm. See
Queue Scheduling
Table 1-3 802.1p-to-local precedence mapping table
0
1
2
3
4
5
for the default mapping.
802.1p priority
1-32
Chapter 1 QoS Configuration
Local precedence
7
6
5
4
3
2
Configuring