H3C S9500 Series Operation Manual page 1065

Operation Manual – QoS
H3C S9500 Series Routing Switches
2.2.2 Configuring the Number of Tokens for Port or Port Queue
Follow these steps to configure the number of tokens for port or port queue:
Enter system view
Configure the total number
of tokens for each specified
port or the number of tokens
for a specified queue of
each specified port
Caution:
100 Mbps Ethernet ports do not support the qos token command.
Ports on the LSB1TGX1B and LSB1GV48DB boards do not support the qos token
command.
On the LSB1P4G8B, LSB1P4G8C, LSB1P4G8CA and LSB1SP4CA boards, you
can configure the qos token command on only one of the four POS ports.
On the LSB1XP4B and LSB1XP4CA boards, port 1 and 3 support the qos token
command, while port 2 and 4 do not support the command.
2.3 Port Tokens Configuration Example
I. Configuration procedure
# Set the total number of tokens for port GigabitEthernet 3/1/1 to 30.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] qos token GigabitEthernet3/1/1 30
# Set the number of tokens for queue 2 on port GigabitEthernet 3/1/1 to 5.
<H3C> system-view
System View: return to User View with Ctrl+Z.
[H3C] qos token GigabitEthernet3/1/1 queue 2 5
To do...
system-view
qos token interface-list
[ queue queue-id ]
token-number
Chapter 2 Port Tokens Configuration
Use the command...
2-2
Remarks
—
Optional
interface-list is a port list,
in which you can specify
the following ports:
Ethernet port, POS port
and RPR logical port.