H3C S9500 Series Operation Manual page 913

Operation Manual – MPLS L3VPN
H3C S9500 Series Routing Switches
By default, the vlan-id range of MPLS/VPN VLANs is from 0 to 1023, and the default
value of vlan-id is 0. The value range of vlan-id is from 1 to 3071.
Caution:
This command is only applicable to fast Ethernet ports on the cards with suffix C.
This command can only be executed on Trunk ports, and MPLS/VPN-enabled
VLANs and VLANs out of the configured range are excluded..
Set the VPN range for the cards and set the range of MPLS/VPN VLAN vlan-id on
the interface of the card to 1 to 4094.
Perform the following configuration in system view to configure the MPLS/VPN VLAN
vlan-id range for the card:
Enable the 4K VPN-range for the card
Disable the 4K VPN-range for the card
Caution:
This command is only applicable to fast Ethernet ports on the cards with suffix C.
This command is actually effective for only the first 12 ports on the card. When you
configure MPLS/VPN VLAN vlan-id on subsequent ports, only the MPLS/VPN
VLAN range enabled for one VLAN will take effect. If you remove MPLS/VPN
configuration from an active port, no subsequent port will take effect automatically
either, and you have to reconfigure the ports to update their states.
For F32GC card, 4 GE ports are initialized for 4k VLANs. Of 32 FE ports, only the
first 8 ports will take effect.
Restart the card after issuing a command or its corresponding undo command to
ensure that the configuration takes effect.
After you cancel card configuration, if the VLAN configured on a port exceeds 1K,
which is the default value, the configuration will be deleted automatically.
In aggregation mode, VPN-range configuration will not be synchronized
automatically and you can manually make/remove the configuration on an individual
port.
To do...
1-16
Chapter 1 MPLS L3VPN Configuration
Use the command...
vlan vpn-range slot slot-number
enable
undo vlan vpn-range slot slot-number
enable