H3C S9500 Series Operation Manual page 1084

Operation Manual – QoS
H3C S9500 Series Routing Switches
To do...
Enter system view
Configure a time
range
Enter ACL view
Define a rule
Exit ACL view
Enter ACL view
Define an ACL rule
for BT rate limit
Exit ACL view
Enter VLAN view
Configure BT traffic
policing
Exit VLAN view
Use the command...
system-view
time-range time-name
{ start-time to end-time
days-of-the-week [ from
start-time start-date ] [ to
end-time end-date ] | from
start-time start-date [ to
end-time end-date ] | to
end-time end-date }
acl { number acl-number |
name acl-name [ advanced |
basic ] } [ match-order
{ config | auto } ]
rule
quit
acl { number acl-number |
name acl-name [ advanced |
basic ] } [ match-order
{ config | auto } ]
rule [ rule-id ] { permit | deny }
tcp [ packet-level { bridge |
route } | source { source-addr
wildcard | any } | destination
{ dest-addr wildcard | any } |
source-port operator port1
[ port2 ] | destination-port
operator port1 [ port2 ] ] *
bt-flag [ time-range name ]
quit
vlan vlan-id
traffic-limit outbound
ip-group { acl-number |
acl-name } [ rule rule
[ system-index index ] ]
[ tc-index index ] traffic-index
traffic-index { conform
{ remark-cos |
remark-policed-service } |
exceed { forward | drop } } *
slot slot-id
quit
6-2
Chapter 6 EACL Configuration
Remarks
—
Optional
Required
Required
This ACL rule is used for
traffic redirecting on the
port.
—
Required
This command is used to
create the ACL rule used
for BT rate limit. This
command does not
support Layer 2 ACL
The rule with bt-flag is
used for BT rate limit
—
—
Required
Deliver the ACL rule with
bt-flag to VLAN
—