H3C S9500 Series Operation Manual page 1469

Operation Manual – PoE
H3C S9500 Series Routing Switches
Slot 3 is provided with 400 W power and slot 5 is provided with full power.
The input power of the AP device connected to GigabitEthernet 5/1/2 cannot be
greater than 9,000 mW.
II. Network diagram
Figure 1-1 PoE power supply
III. Configuration procedure
# Set the maximum power to 400 W on the card in slot 3. By default, the power of each
card is full, so the power on the card in slot 5 need not be configured.
<H3C> system-view
[H3C] poe max-power 400 slot 3
# Enable PoE on the ports GigabitEthernet 3/1/1 and GigabitEthernet 3/1/2.
[H3C] interface GigabitEthernet3/1/1
[H3C-GigabitEthernet3/1/1] poe enable
[H3C-GigabitEthernet3/1/1] quit
[H3C] interface GigabitEthernet3/1/2
[H3C-GigabitEthernet3/1/2] poe enable
[H3C-GigabitEthernet3/1/2] quit
# Enable PoE on the ports GigabitEthernet 5/1/1 and GigabitEthernet 5/1/2.
[H3C] interface GigabitEthernet5/1/1
[H3C-GigabitEthernet5/1/1] poe enable
[H3C-GigabitEthernet5/1/1] quit
[H3C] interface GigabitEthernet5/1/2
[H3C-GigabitEthernet5/1/2] poe enable
[H3C-GigabitEthernet5/1/2] quit
# Set the PoE priority of the port GigabitEthernet 3/1/2 to critical.
[H3C] interface GigabitEthernet3/1/2
[H3C-GigabitEthernet3/1/2] poe priority critical
[H3C-GigabitEthernet3/1/2] quit
GE3/1/1
GE5/1/1
GE5/1/2
GE3/1/2
AP
AP
1-6
Chapter 1 PoE Configuration