H3C S9500 Series Operation Manual page 1259

Operation Manual – Traffic Accounting
H3C S9500 Series Routing Switches
802.1X or Portal is enabled in the switch.
CAMS server finishes the configuration.
Note:
This article is to introduce the configuration of traffic statistics. The configuration of
802.1X or Portal or CAMS server is not covered here.
1.2.2 Configuring Traffic Accounting
Follow these steps to configure traffic accounting:
Enter system view
Configure the port mirror
group of traffic collection
Configure the slot for
traffic statistics
Enable the traffic statistics
function
Configure the traffic group
Display the configured
traffic group information
Configure the traffic group
address
To do...
system-view
mirroring-group groupid
{ inbound | outbound }
mirroring-port-list
mirrored-to monitor-port
traffic-accounting
accounting-slot slot-num
accounting enable
traffic-accounting
traffic-group
group-name
display
traffic-accounting
traffic-group
[ group-name ]
network ip-address
{ mask | masklen }
Chapter 1 Traffic Accounting Configuration
Use the command...
1-3
Remarks
—
Required
Refer to QoS Commands
in the QoS ACL Volume
for more information.
Required
Specify the traffic
accounting slot where
the traffic accounting
board resides in.
Enter traffic statistics
view automatically
after successful
configuration.
Required
This command is
configured in the traffic
statistic view.
Required
Enter traffic group view
automatically after
successful configuration.
Optional
Required
This command is
configured in the traffic
group view.