Configuring Vbas; Vbas Configuration Example - H3C S9500 Series Operation Manual

Operation Manual – VBAS
H3C S9500 Series Routing Switches

1.2 Configuring VBAS

1.2.1 VBAS Configuration Procedure
Follow these steps to configure VBAS:
Enter system view
Configure Layer 3 interface of
the VLAN where BAS access
port resides
Back to system view
Enable
VBAS
function
Back to system view
Set the type of
AccessNodeIdentifier

1.3 VBAS Configuration Example

I. Network requirements
Enable VBAS function on VLAN 2 of the S9500 switch.
The switch uses RADIUS server to complete authentication and accounting.
VBAS packet passes between the S9500 switch and the BAS server.
BAS acquires the S9500 port number connected with the Client, and accesses to
the broadband after passing the authentication.
To do...
Enable VBAS
function on the
VLAN where BAS
access port resides
Enable VBAS
function on the
BAS access port
Use the command...
system-view
vlan vlanid
interface vlan vlanid
ip address ip_address
mask
quit
vlan vlanid
vbas enable
interface interface-type
interface-number
vbas enable
quit
vbas deviceId_type
[ sysname | bridge_mac ]
1-2
Chapter 1 VBAS Configuration
Remarks
—
Optional
You can specify the
destination MAC
on BAS as the
interface MAC of
the switch or as the
bridge MAC of the
switch (here it is
not necessary to
configure the Layer
3 interface).
—
Required
This configuration
activates VBAS
function of the
VLAN or the port.
—
Optional
The default type is
Bridge_mac.