H3C S9500 Series Operation Manual page 1303

Operation Manual – Login and User Interface
H3C S9500 Series Routing Switches
management port and service ports and packets are not forwarded between them. You
can use the network management port dedicatedly to manage the switch, and enabling
IP isolation on the management port will not affect data communication service of the
switch.
If this feature is enabled, the network management port and the service ports cannot
communicate with each other and the switch will drop the packets to be forwarded
between the network management port and the service ports. Otherwise, the switch
can forward packets between the network management port and the service ports.
Use the following commands to enable IP isolation between the network management
port and the service ports.
Follow these steps to configure IP isolation:
Enter system view
Enter network
management port view
Enable IP isolation
between the network
management port and the
service ports.
To do...
system-view
interface M-Ethernet
m-ethernet
ip isolation
Chapter 3 Management Port Configuration
Use the command...
3-2
Remarks
—
—
Optional
This feature is disabled by
default.