Mitel 6800 Series SIP Phone Release 4.2.0 SP2 Administrator Guide
INSTALLATION REQUIREMENTS
The following are general requirements for setting up and using your SIP IP phone:
•
SIP-based IP PBX system or network installed and running with a SIP account created for
the IP phone
•
Access to a Trivial File Transfer Protocol (TFTP), File Transfer Protocol (FTP), Hypertext
Transfer Protocol (HTTP) server, or Hyper Text Transfer Protocol over Secure Sockets
Layer (SSL) (HTTPS)
•
Ethernet/Fast Ethernet LAN (10/100 Mb) (Gigabit Ethernet LAN [1000 Mbps] recommended
for Gigabit Ethernet compliant phones)
•
Category 5/5e straight through cabling (Category 6 straight-through cabling recommended
for Gigabit Ethernet compliant phones)
•
Power source (6863i, 6865i, 6867i, and 6869i)
•
For Ethernet networks that supply inline power to the phone (IEEE 802.3af) use an
Ethernet cable to connect from the phone directly to the network for power (no 48V AC
power adapter required if using Power-over-Ethernet [PoE])
•
For Ethernet networks that DO NOT supply power to the phone:
•
Use the respective power adapter to connect from the DC power port on the phone
to a power source
or
•
Use a PoE power injector or a PoE switch
•
Power source (6873i)
•
For Ethernet networks that supply inline power to the phone (IEEE 802.3af or IEEE
802.3at [IEEE 802.3at recommended]) use an Ethernet cable to connect from the
phone directly to the network for power (no 48V AC power adapter required if using
Power-over-Ethernet [PoE] or PoE plus)
•
For Ethernet networks that DO NOT supply power to the phone:
•
Use only the GlobTek Inc. Limited Power Source [LPS] adapter model no.
GT-41080-1848 (sold separately) to connect from the DC power port on the phone
to a power source
or
•
Use a PoE power injector or a PoE switch (PoE plus recommended)
1-21