Mitel 6800 Series Administrator's Manual page 133

PARAMETER PARAMETER IN
IN MITEL WEB UI
IP PHONE UI
N/A Autodial Timeout
(Global and
Per-Line)
N/A Use Global
Settings
(Per-line
configurations
only)
PARAMETERS IN DESCRIPTION
CONFIGURATION
FILES
sip autodial timeout Globally or on a per-line basis, specifies the
time, in seconds, that the phone waits to
dial a pre-configured number after the
sip lineN autodial
handset is lifted from the IP phone cradle.
timeout
If this parameter is set to 0 (hotline), the
phone immediately dials a pre-configured
number when you lift the handset. If this
parameter is set to a value greater than 0,
the phone waits the specified number of
seconds before dialing the pre-configured
number (warmline) when you lift the
handset.
Default is 0 (hotline).
For more information, see Chapter 4,
"Autodial Settings"
N/A For each line, this parameter specifies to
use the global autodial settings of "Autodial
Number" and "Autodial Timeout".
For more information, see Chapter 4,
"Autodial Settings"
Administrator Level Options
on page 4-98.
on page 4-98.
3-62