Mitel 6800 Series Administrator's Manual page 778

Mitel 6800 Series SIP Phone Release 4.2.0 SP2 Administrator Guide
PARAMETER –
https user certificates
DESCRIPTION
FORMAT
DEFAULT VALUE
RANGE
EXAMPLE
A-36
CONFIGURATION FILES
startup.cfg, <model>.cfg, <mac>.cfg
Specifies a file name for a .PEM file located on the configuration
server. This file contains the User-provided certificates in PEM
format. These certificates are used to validate peer certificates.
Note: To install a user-provided certificate through a configuration
server using the HTTPS protocol, you must temporarily disable the
"https validate certificates". After the certificate is installed and you
can re-enable the "https validate certificates" parameter.
You can use this parameter in three ways:
• To download no certificates
• To download a certificate from the original configuration server
• To download a certificate from another specified server
To download a specific file, the string value MUST HAVE A
FILENAME at the end of the string. For example:
https user certificates:
ftp://admin:admin!@1.2.3.4:50/path/phonesHTTPSUserCert.pem
where "path" is the directory and "phonesHTTPSUserCert.pem" is
the filename. If you do not specify a filename, the download fails.
See examples for each below.
Alphanumeric string in the format <filename.pem>
N/A
N/A
The following example downloads no HTTPS user certificate file:
https user certificates:
The following example downloads the HTTPS user certificate file
from the original configuration server.
https user certificates: phonesHTTPSUserCert.pem
The following example uses FTP to download the firmware file
"phonesHTTPSUserCert.pem" (HTTPS user certificate file) from the
"path" directory on server 1.2.3.4 using port 50:
https user
certificates:ftp://admin:admin!@1.2.3.4:50/path/phonesHTTPSUser
Cert.pem