Mitel 6800 Series Administrator's Manual page 429

CONFIGURATION
PARAMETER
hardkeyN ring splash
DESCRIPTION
When a key is configured for BLF or BLF/List functionality, this parameter
controls the ring splash alert pattern per key. The following alerting
patterns are available:
0. Silence (ring splash off).
1. Normal (same as current BLF ring splash).
2. Normal delayed (After a delay of [x] seconds, the ring signal that is the
same as the current BLF ring splash is played [use the "ring splash
delay" parameter to define the delay]).
3. Periodic (similar to the normal ring signal that is used by the phone itself.
The actual ring melody is based on the current melody set for the line to
which the BLF key is associated).
4. Periodic delayed (same as Periodic but after a delay of [x] seconds, the
ring signal that is used by the phone is played [use the "ring splash
delay" parameter to define the delay]).
5. Low volume (same as the current BLF ring splash but at a lower level to
be less intrusive).
6. Low volume delayed (after a delay of [x] seconds, the ring signal that is
the same as the current BLF ring splash is played at a lower level [use
the "ring splash delay" parameter to define the delay]).
7. The behavior is determined by the global parameter "play a ring splash".
• If "play a ring splash" is defined as 0 then the feature is disabled.
• If "play a ring splash" is defined as 1 then the behavior is the same
as Normal.
• If "play a ring splash" is defined as 2 then the behavior is the same
as Normal but the ring splash plays when idle and also during the
active call state.
8. In call delayed (same as Normal delayed but ring splash plays when idle
and also during the active call state [use the "ring splash delay"
parameter to define the delay]).
9. In call periodic (same as Periodic but ring splash plays when idle and
also during the active call state [use the "ring splash frequency"
parameter to define the ring splash frequency interval for the active call
state]).
10. In call periodic delayed (same as Periodic delayed but ring splash
plays when idle and also during the active call state [use the "ring
splash delay" parameter to define the delay for the active and idle call
state and the "ring splash frequency" parameter to define the ring
splash frequency interval for the active call state]).
11. In call low volume (same as Low volume but ring splash plays when
idle and also during the active call state).
12. In call low volume delayed (same as Low volume delayed but ring
splash plays when idle and also during the active call state [use the
"ring splash delay" parameter to define the delay]).
Ring tones are based on the current ring tone set configured on the
Note:
SIP phone. Ring splashes will not be played if a custom ring tone has been
selected by the user.
Operational Features
5-166