Broadsoft Broadworks Executive And Assitant Services Settings - Mitel 6800 Series Administrator's Manual

Mitel 6800 Series SIP Phone Release 4.2.0 SP2 Administrator Guide
prefix. The prefix itself is not displayed on the phone's screen (e.g. in the case outlined above,
the phone will only display "Filtrage -> Dupont, Francois").
The "sip execassist fac call push" parameter is used to specify the Feature Access Code
(FAC) that is used to push a filtered call from the Assistant's phone back to the Executive's
phone. The FAC should correspond to the value configured for the "Executive-Assistant Call
Push" setting defined in the BroadSoft Web portal.
The "sip execassist fac initiate call" parameter is used to specify the FAC that is used by
Assistants to initiate a call on behalf of the Executive. The FAC should correspond to the value
configured for the "Executive-Assistant Initiate Call" setting defined in the BroadSoft Web portal.
Use the following parameters to configure the BroadSoft Executive and Assitant Services
feature:
CONFIGURATION FILES
For the specific parameters you can set in the configuration files, see Appendix A, the section,

"BroadSoft BroadWorks Executive and Assitant Services Settings"

FILTER SOFTKEY
In addition to the new parameters, a "Filter" softkey type has been introduced allowing both
Executives and Assistants the ability to easily activate and deactivate the Executive Call
Filtering feature.
Note: The As-Feature Event Subscription option must also be enabled for the Filter
softkey to function. This feature can be enabled by defining the
"sip lineN as-feature-event subscription" parameter as "1" in the configuration files
(where "N" corresponds to the applicable line) or through the phone's Web UI under
Advanced Settings > LineN > Advanced SIP Settings > As-Feature-Event
Subscription. Refer to
details on the As-Feature Event Subscription feature.
Filter Softkey for the Executive's Phone
The Executive's phone requires that only one Filter softkey be configured. The Filter softkey's
value can either be left undefined (which will toggle the Executive Call Filtering settings on the
call manager via the SIP SUBSCRIPTION/NOTIFY mechanism) or, it can be defined using the
following values (which will toggle the settings via an FAC call):
• Executive Call Filtering Activation FAC (e.g. "#61")
• Used when the Deactivation FAC is in the same format as the Activation FAC but
sequentially one number above the Activation FAC. For example, if the softkey value
is defined as "#61" (the Activation FAC), the phone will automatically assume that the
Deactivation FAC is "#62" and will use that code to deactivate Executive Call Filtering.
• Executive Call Filtering Activation FAC followed by a semi-colon and then Executive Call
Filtering Deactivation FAC (e.g. "#61;*61" or "#61;#71")
• Used when the Activation and Deactivation FACs are not in the same format or when
they are not sequential. For example, if the Activation FAC is configured in the BroadSoft
6-91
"As-Feature-Event Subscription"
on .
page A-312
on page 6-14 for additional