Configuration Requirements - Mitel MiVOICE Installation Manual

Installing the Security Plate (Recommended)
B
Note: Refers to all the diagrams below.
You can install a security plate to secure the cables and devices.

Remove only the two screws shown from the bottom of the phone. Do not
remove any other screws.

Thread the tie wrap through the slot as shown.

Place the HDMI cable through the slot on the back of the phone, placing it
on top of the tie wrap. Plug it into the HDMI port.

Secure the HDMI cable with the tie wrap provided in the kit. (Trim the excess
tie wrap, if necessary.)

Connect the other end of the HDMI cable into the HDMI device or another
HDMI cable.

B
Install the other cables and devices as described in "Installing the MiVoice
Conference Phone or MiVoice Video Phone" on page 2. Also refer to
Figure

Place the security mounting plate over the cables.

Important: Use the new longer screws provided in the kit to secure the plate
in place.

Configuration Requirements

The MiVoice Conference Phone and/or the MiVoice Video Phone must be
licensed, programmed, and registered with the communications platform. Refer
to your communications platform documentation for instructions.
NOTE:
Conference/Video Phone documentation are available on the Mitel Customer
Documentation web site. See "Supporting Documentation" on page 2 for more
information.
Notice to Canadian Customers
Contains IC: 5969A-TIWI1-01
The term "IC:" before the certification/registration number only signifies that
registration was performed based on a Declaration of Conformity indicating that
Industry Canada technical specifications were met. It does not imply that
industry Canada approved the equipment.
This device complies with Industry Canada License-exempt RSS standard(s).
Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
A
on the front of this installation guide.
Communication platform documentation and associated MiVoice
3