Speeddial Key Mapping - Mitel 6800 Series Administrator's Manual

Mitel 6800 Series SIP Phone Release 4.2.0 SP2 Administrator Guide
5. In the "Label" field, enter a key label to assign to the Paging key (for example, "Group 1").
6. In the "Value" field, enter a multicast IP address and a port number for the Paging key.
When you press this key, the phone initiates an outgoing multicast RTP session to the
specified address using the specified port. (For example, 224.0.0.2:10000).
Notes:
1. When you select Paging for the "Type" field, the "Line" field and state fields are
2. The valid port range is from 1 to 65535.
7. Click Save Settings to save your changes.
Using the Configured Paging Key on the IP Phone
The following procedure describes the use of the Paging key. The procedures assumes you
have already configured the Paging key using the configuration files or the Mitel Web UI.
Notes:
1. The recipient of a Paging call can set a global "Do Not Disturb" (DND) to ignore any
incoming pages.
2. For incoming Paging, the phones use the Intercom configuration settings. The
incoming Page is dependent on the "Allow Barge-In" parameter setting and the
"Idling/On Call" state.
IP PHONE UI
1. On the IP Phone, press the key you configured for Paging.
The phone opens a multicast RTP session and an outgoing OR incoming phone screen
displays.
Note:
2. Press the Drop key to end the multicast RTP session and return to the idle screen.

SPEEDDIAL KEY MAPPING

There are hard keys on your phone, such as Hold, Redial, Xfer, and Conf that are configured
by default for specific call-handling features. (See the <Model-Specific> SIP Phone User Guide
for more information about these key functions).
ENABLING/DISABLING REDIAL, XFER, AND CONF KEYS
You can enable or disable the Redial, Xfer, and Conf keys as required using the following
parameters in the configuration files:
• redial disabled
• conference disabled
• call transfer disabled
5-109
disabled.
If you enable global DND on the phone, the incoming multicast RTP session is dropped.