Table of Contents
Advertisement
3HAC023082-001 Revision: E
Action
2. Make sure the two o-rings (C, D) on the cir-
cumference of the gearbox are seated
properly in their grooves respectively.
Lubricate them with grease .
Make sure the small o-ring around the oil hole
is fitted properly!
3. Refit the cable guide in the center of gearbox
1 with its attachment screws.
4. Fit the lifting device, base and the lifting tool
(chain) to the gearbox.
5.
CAUTION!
The gearbox weighs 160 kg! All lifting
equipment used must be sized accordingly!
6. Lift the gearbox to its mounting position in the
center of the base.
7. Make sure the guide pin in the bottom face of
the gearbox is properly aligned with the base.
4.7.1. Replacement of gearbox, axis 1
Note/Illustration
Art no. is specified in
Required
equipment on page
383!
xx0200000055
•
A: Guide pin
•
C: O-ring 3HAB 3772-54
•
D: O-ring 3HAB 3772-55
•
E: Sealing ring 3HAC 11581-4
xx0200000256
•
A: Location for attachment
screws, cable guide (cable
guide removed in figure)
Art no. is specified in
Required
equipment on page
383!
Shown in the figure xx0200000055
above!
Continues on next page
4 Repair
Continued
387
Advertisement
Table of Contents
