Table of Contents
Advertisement
Securing the lower arm
The procedure below details how to secure the lower arm by fitting the fixture to the robot.
3HAC023082-001 Revision: E
Action
1.
DANGER!
Turn off all electric power, hydraulic and pneumatic
pressure supplies to the robot!
For Foundry Prime robots: Do not turn off the air
pressure to motors and SMB.
2. Remove any load or equipment fitted to the upper
arm or turning disk.
3. Move the robot to the calibration position. The upper
arm can be directed in three different ways, shown in
the figure to the right.
The lowered position, as in figure A, is
recommended as it gives the least load on the tool.
4. If the robot is fitted with moveable mechanical stops
on axis 2 (not stock equipment), these must be
removed at this point.
The attachment holes of the mechanical stops are
used to attach the fixture.
5. Remove the locking screw from the fixture, where it
is attached.
6. Secure the lower arm to the frame by inserting the
locking screw into a specific attachment hole
through the frame, into the lower arm.
4 Repair
4.4.7. Securing the lower arm
Continued
Note/Illustration
xx0200000260
Shown in the figure
Fixture, lower
arm on page
306.
Art. no. of the fixture is specified in
Required equipment on page
Shown in the figure
Attachment
points, robot on page
305.
Continues on next page
306.
307
Advertisement
Table of Contents
