Table of Contents
Advertisement
Equipment
Plate for customer
connections
Additional cabling to and
inside the controller
Locking liquid
Standard toolkit
Circuit diagram
Other tools and procedures
may be required. See
references to these
procedures in the step-by-
step instructions below.
Plate for customer connections, at base
xx0500002301
A
B
3HAC023082-001 Revision: E
2.5.11. Installation of cooling fan for motors, axes 1-3 (option)
Art. no.
3HAC025778-001
-
-
-
-
Plate for customer connections
Attachment screws, 3 pcs, M6x16
2 Installation and commissioning
Note
An additional connection plate must be
fitted to the robot base, if not already
installed. The plate is shown in the figure
Plate for customer connections, at base
on page
99.
Specified in section
fan cables, robot base to controller
(option) on page
123.
Loctite. Used for the three tightening
screws.
The contents are defined in section
Standard toolkit on page
the Product manual.
See chapter
Circuit diagram
Product manual, reference
These procedures include references to
the tools required.
Continues on next page
Continued
Position switch and
436, in part 2 of
in the
information.
99
Advertisement
Table of Contents
