Calibration Methods - ABB M2000 Product Manual

5 Calibration information

5.2. Calibration methods

5.2. Calibration methods
Overview
This section specifies the different types of calibration and the calibration methods that are
supplied from ABB.
Types of calibration
Type of
calibration
Standard
calibration
Absolute Accuracy
calibration
(optional)
164
Description
The calibrated robot is positioned at home
position, i.e. the axes positions (angles) are
set to 0º.
Standard calibration data is found in the file
calib.cfg, supplied with the robot at delivery.
The file identifies the correct resolver/motor
position corresponding to the robot home
position.
From deliveries together with RobotWare 5.0.5
and higher, the data will instead be found on
the SMB (serial measurement board) in the
robot, and not in a separate file.
Based on standard calibration, but besides
positioning the robot at home position, the
Absolute Accuracy calibration also
compensates for:
• mechanical tolerances in the robot
structure
• deflection due to load.
Absolute Accuracy calibration focuses on
positioning accuracy in the Cartesian
coordinate system for the robot.
Absolute Accuracy data is found in the file
absacc.cfg, supplied with the robot at delivery.
The file replaces the calib.cfg file and identifies
motor positions as well as absacc-
compensation parameters.
From deliveries together with RobotWare 5.0.6
and higher, the data will instead be found on
the SMB (serial measurement board) in the
robot, and not in a separate file.
A robot calibrated with AbsAcc has a sticker
next to the identification plate of the robot.
To regain 100% Absolute Accuracy
performance, the robot must be recalibrated
for Absolute Accuracy!
xx0400001197
Calibration method
Calibration Pendulum
(standard method)
or
Levelmeter calibration
(alternative method)
CalibWare
3HAC023297-001 Revision: A