Table of Contents
Advertisement
24.6
Description
Configure hidden point
connection step-by-
step
Config...\Interfaces... - Controlling Devices
Hidden Point Measurement Devices
Hidden point measurement devices can be used to measure distances, angles and azimuths
to points which are not accessible by means of GPS. A Bluetooth housing can be used to
provide a wireless connection between the receiver and a Bluetooth enabled hidden point
measurement device.
The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step
Description
1.
Refer to "22.2 Accessing Configuration Interfaces" to access
CONFIGURE Interfaces.
2.
In CONFIGURE Interfaces highlight an interface which has a hidden
point measurement device attached.
3.
CTRL (F4) to access CONFIGURE RS232 Connection.
4.
CONFIGURE RS232 Connection
<Type:> The type of hidden point measurement device highlighted
when CONFIGURE RS232 Connection was accessed.
<Bluetooth:> GPS1200+ receivers detect automatically if the
attached devices is bluetooth capable. Some devices ask for the
identification number of the Bluetooth. The identification number of
Leica's Bluetooth is 0000. The field is unavailable for RX1250 with
SmartAntenna.
GPS1200+
Refer to
chapter
23
613
Advertisement
Table of Contents
