Creating A New Line/Area - Leica GPS1200+ Technical Reference Manual

9.4.2
Access
Create line step-by-step
Manage...\Data

Creating a New Line/Area

The functionality of all screens and fields are similar for the creation of both lines and areas.
The step-by-step instructions for creating a new line can be applied for areas.
Refer to "9.2 Accessing Data Management" to access MANAGE Data: Job Name.
OR
Press a hot key configured to access the screen MANAGE New Line/MANAGE New
Area. Refer to "6.1 Hot Keys" for information on hot keys.
The following table explains the most common settings. Refer to the stated chapter for more
information on screens.
Step Description
1. MANAGE Data: Job Name
2. PAGE (F6) until the Lines (X) page is active.
3. MANAGE Data: Job Name, Lines (X) page
4. NEW (F2) to access MANAGE New Line.
5. MANAGE New Line, General page
<Line ID:> The name of the new line. The configured ID template for
lines is used. The ID can be changed in the following ways:
• To start a new sequence of line ID's type over the line ID.
• For an individual name independent of the ID template SHIFT
INDIV (F5). SHIFT RUN (F5) changes back to the next ID from
the configured ID template.
GPS1200+
Refer to
chapter
187