Leica GPS1200+ Technical Reference Manual page 851

COGO
Step Description
<1st Point:> The point ID of the known start point of the first line for
the COGO calculation.
<2nd Point:> The point ID of the known end point of the first line for
the COGO calculation.
Select the points stored in the job.
SURVY (F5) when <1st Point:> or <2nd Point:> is highlighted.
manually occupy
For all point fields, the MapView interactive display on the Map page
can be used to select the desired point.
To type in coordinates for a known point open the choicelist when
<1st Point:> or <2nd Point:> is highlighted. Press NEW (F2) to
create a new point.
3. COGO Intersection Input, Input page
<Offset:> Available for <Use Offsets: Yes> in COGO Configura-
tion, Parameters page. The offset of the line in the direction <1st
Point:> to <2nd Point:>. A positive offset is to the right, a negative
offset is to the left.
Type in the offset if required.
The value for the offset can be calculated from two existing points.
INV (F2) when <Offset:> is highlighted. To perform a COGO inverse
calculation.
a point for the COGO calculation.
GPS1200+
Refer to
chapter
45.3
To
33.5
9.3.2
38.4
851