Config...\Interfaces... - General
Field
Option
NETx
Port x
Port 1
<End of Msg:> CR, LF or CR/LF
From <Annota-
Output
tion 1:> to
<Annotation
4:>
Next step
CONT (F1) returns to the screen from where CONFIGURE ASCII Input was accessed.
Description
Available for an activated Internet interface. If these
ports are not assigned to a specific interface, then
these ports are additional remote ports.
The physical port P1, P2 or P3 on the instrument to
which the device is attached.
Available for RX1250. LEMO port on RX1250.
The character to be used to identify the end of the
incoming ASCII message.
The description of the ASCII input as configured with
ANNOT (F2).
If the seismic record is configured to be used then the
default is <Annotation 4: Seismic>.
GPS1200+
518