Leica GPS1200+ Technical Reference Manual page 869

Geodetic satellite receiver
Hide thumbs Also See for GPS1200+:
Table of Contents

Advertisement

COGO
Step
Description
<No. of Segs:> For <Method: No. of Segments> type in the number
of segments for the line. For <Method: Segment Length> type in the
segment length for the line. A remaining segment may result from this
method.
<Seg Length:> For <Method: No. of Segments> this is the calcu-
lated length of each segment. For <Method: Segment Length> type
in the required segment length.
<Last Seg Lgth:> Available for <Method: Segment Length>. The
length of the remaining segment.
<Start PtID:> The point ID to be assigned to the first new point on the
line. The selected point ID templates from CONFIGURE ID
Templates are not applied.
<PtID Inc:> <Start PtID:> is incremented numerically for the second,
third, etc. point on the line.
5.
CALC (F1) to access COGO Segmentation Results.
The coordinates of the new points are calculated. The heights are
computed along the line assuming a linear slope between <Start
Point:> and <End Point:>.
6.
COGO Segmentation Results, Result page
<Number of Segments:> Describes the number of resulting
segments for the line including the remaining segment, if it applies.
GPS1200+
Refer to
chapter
869

Advertisement

Table of Contents
loading

Table of Contents